Here you see the flashing port (machine pins female) for Silverware and on the left the 5 pin Plug (I used 2mm pitched socket boards) for the 4 ESC servo wires and GND

Part List:

• DYS BE 1104 5400 kV
• Tarot 120mm Frame Kit
• Power Distribution Board (Cut Down the half of the Solder points, so I have only 4 remaining)
• Sunrise Cicada 10A BLHeli_S ESCs
• HQ 3030 props, they need to be cut down a little. I used a Dremel with a Line and Circle Cutter. With them, you're able to fly upside down!
• Eachine 3020 props for normal flying
• 2S or 3 S batteries between 300 and 500 mAh (I use 1S 350 Walkera lipos at the moment and put them in a row using 2mm banana plugs
• 2mm banana plugs
• ST Link for flashing Silverware
• BLHeli-Box for flashing the ESCs and configure them in the field. (Can be USB powered) For using a Laptop, you need at least an Arduino Nano (or the box of course)
• Some wires, maybe Jumper Wires or an old IDE 40Pin Cable
• Time and patience

How I built it (sorry I did no pictures - in case I have to disassemble the quad sometimes, I'll hand them in later)