Table of contents
- Before you start
- Beginner's Guide
- Downloads
- Configuration
- Compatibility
- Telemetry
- WHOOP Section
- Troubleshooting
- SilverHardware
- Go Brushless
- Tuning a quad
- Quadcopter mods
- Merchandise
- Links
Sidebar
gallery
This is an old revision of the document!
Gallery of awesome pictures
Note: the board pads are not designed for mechanical support, it's best to use a wire size that will break before the pad will. Attaching a solid part to the pad with no other support can result in the pad ripped from the board after a crash.
Flashing port examples
Male 2.54cm header.
Female 2.54cm header.
Picoblade connector.
Solid wire (24gauge?).
CG023 FC with silverxxx firmware on a 110mm brushless quad
gallery.1478943360.txt.gz · Last modified: 2016/11/12 10:36 by silverxxx
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
