User Tools

Site Tools


Sidebar

Table of contents

walkera_ladybird_3d

This is an old revision of the document!


Walkera Ladybird silverxxxed

I digged out that little guy. He was only sitting around, because binding with the TX was always luck-dependant. Perhaps a broken layer on the FC?

Anyway, I had to resurrect him!

  • Weight is 25g without battery
  • Flight time with a little weak 333mAh mylipos amazing 7 minutes!
  • Motors 7×20

img_20160401_235006.jpg

Some might not see any difference...

img_20160401_235025.jpg

...but that is not an original propeller, is it? So let's remove the Canopy!

img_20160401_235122.jpg

A red board? Yeah! I added a H101 FC to it!

img_20160401_235159.jpg

I had to cut down the edges to fit under the Canpy. That causes losing the LEDs.
But not a big deal: Stock   FC also has a small LED on the top of the Board only...

img_20160401_235301.jpg

OK, the Cap is a little large, but was the only one with enough capacity I had laying around... Doesn't
matter, It's not that heavy...

img_20160401_235235.jpg

2mm Goldies for better Battery connection and more "punch". Unfortunately my batteries got weak a little
while laying around, too...

img_20160401_234956.jpg

I let him the stock 7x20 motors. They are already run for several hours, but doing full and half flips is
not a problem, also flying inverted is very cool as because of the heavy motors far away from center, It
flies a bit more chilled. That is cruising!
This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
walkera_ladybird_3d.1479769962.txt.gz · Last modified: 2016/11/22 00:12 by sirdomsen