Table of contents
- Before you start
- Beginner's Guide
- Downloads
- Configuration
- Compatibility
- Telemetry
- WHOOP Section
- Troubleshooting
- SilverHardware
- Go Brushless
- Tuning a quad
- Quadcopter mods
- Merchandise
- Links
This is an old revision of the document!
I digged out that little guy. He was only sitting around, because binding with the TX was always luck-dependant. Perhaps a broken layer on the FC?
Anyway, I had to resurrect him!
Some might not see any difference...
...but that is not an original propeller, isn't it? So let's remove the Canopy!
A red board? Yeah! I added a H101 FC to it!
I had to cut down the edges to fit under the Canpy. That causes losing the LEDs. But not a big deal: Stock FC also has a small LED on the top of the Board only...
OK, the Cap is a little large, but was the only one with enough capacity I had laying around... Doesn't matter, It's not that heavy...
2mm Goldies for better Battery connection and more "punch". Unfortunately my batteries got weak a little while laying around, too...
I let him the stock 7x20 motors. They are already run for several hours, but doing full and half flips is not a problem, also flying inverted is very cool as because of the heavy motors far away from center, It flies a bit more chilled. That is cruising!