Table of contents
- Before you start
- Beginner's Guide
- Downloads
- Configuration
- Compatibility
- Telemetry
- WHOOP Section
- Troubleshooting
- SilverHardware
- Go Brushless
- Tuning a quad
- Quadcopter mods
- Merchandise
- Links
This is an old revision of the document!
This Wiki should introduce and help in and on a project, RCGroups user silverxxx has started in september 2015. Have a nice reading!
Feel free to leave a comment right at the bottom of the start page.
Lately, there is a readme in this Wiki that provides a short overview of what Silverware is capable of and provides some quickstart infos.
Features:
fgdg
Question | Answer |
---|---|
“Error, Flash download failed - Could not load file '/.axf” | Project not compiled, go to 'Project → Build Target (or press F7). Errors in code may be causing compilation to fail. Check that the number of errors is zero when compiling. |
“No target connected” | Quad not powered on, you need to supply power to the board; either plug the battery, or the serial cable. If powered, check your clk and data connections. This message indicates the computer can't communicate to the quadcopter. |
“Unknown target connected” | Wrong chip selected, go to “Project → Options For Target (Alt + F7)”. New window opens, switch to 'Debug' tab and on top right, press “ST-Link Debugger” Settings button. New window opens, switch to 'Flash Download' tab, select the proper chip family, press Remove, then Add, and then select the proper chip. |
Internal Command Error. Error: Flash Erase failed - Target DLL has been cancelled“ | Your programming wires might be too long. Try to keep them as short as possible. |
ST-link USB communication error or similar popup | Disconnect/reconnect st-link from USB. This may also be a special blue board problem. read here |
Select device menu grayed out | This is from video, use text instructions from post, or skip the related steps |
Question | Answer |
---|---|
What PWM frequency is the best? | The pwm frequency changes the linearity of the motors (due to their inductance) and as such it can have an effect on flight. For 720 motors 8Khz seems to result in linear thrust. Some 6mm motors are similar. Increasing frequency reduces thrust at low throttle, so it can help with wobbles that occur while descending. 820 motors are still somewhat nonlinear even at 32Khz |
Question | Answer |
---|---|
My quad is drifting in flight | Try the accelerometer calibration: Place the copter on a level surface, throttle low, roll&yaw center, and pitch down three (3) times in quick succession. The LEDs will blink alternating while the calibration is in process. |
How do I fly acro without crashing all the time? | “There is an art to flying, or rather a knack. Its knack lies in learning to throw yourself at the ground and miss. … Clearly, it is this second part, the missing, that presents the difficulties.” |
STlink, spare props, good quality motors, batteries and so on.
We all no doubt know the joys of the slow boat from China but hey they are cheap and available at Banggood