Table of contents
- Before you start
- Beginner's Guide
- WHOOP Section
- Go Brushless
- Tuning a quad
- Quadcopter mods
This is an old revision of the document!
This page is based on This RCGroups Post
Devo 7e and other versions update info:
The telemetry is present in deviation firmware in the latest nightlies, currently. That means you may need to flash a recent nightly to make use of telemetry with the bayang protocol, and your flashed quadcopter.
Please back-up the model files, and perhaps other files just in case, when upgrading the transmitter firmware.
To enable telemetry , hit enter when selecting bayang protocol, the same as enabling telemetry for other protocols, such as DSMX
The protocol with telemetry enabled will only bind to a quad with telemetry capability. With telemetry off, it will bind to all quads, including factory firmware, and telemetry quads.
About telemetry data:
The quad sends battery voltage, battery voltage- compensated against throttle , packets received ( reception quality indicator ) , and battery low -led flash signal
Additionally, the tx generates telemetry reception stats.
Telemetry names are shared with the dsm2 protocol, and as such, their names are not very appropriate to describe quantity they represent.
*Fades_L - led battery low flashing= 100 , otherwise 0
*Loss - TX's telemetry reception quality indicator in packets per seconds (max 200)
*Holds - quad's reception indicator in packets per seconds (max 200 )
*RxV -Volt1- real battery voltage
*Batt -Volt2- compensated battery voltage
You could setup some alarms for telemetry data. Make sure you fly in range of telemetry if you rely on them only.
FadesL > 1 will create an alarm that sounds if the leds flash a low battery code
Batt ⇐ 3.40 is ok for low battery alarm - using voltage compensation settings from config.h
Rxv ⇐ 2.90 - real battery voltage - this would be more like a traditional lvc that sounds on max throttle sometimes
The real voltage goes down a lot, so it may not be very useful. An alarm of 2.8 - 3.0 could be used.
Since the telemetry range is shorter compared to the tx range ( with PA ) , there is no point setting an alarm for quad reception strenght, as the telemetry will probably fail before that level is reached.
The quadcopter only sends telemetry after a packet is received from the transmitter. This is to avoid on-air clashes when the code hopping becomes unsyncronized. Because of this, the telemetry rate will go down when reception is poor.