Table of contents
- Before you start
- Beginner's Guide
- Downloads
- Configuration
- Compatibility
- Telemetry
- WHOOP Section
- Troubleshooting
- SilverHardware
- Go Brushless
- Tuning a quad
- Quadcopter mods
- Merchandise
- Links
This is an old revision of the document!
This LOS quad was built using a GW008 (skull drone) FC with CG023 firmware, buck regulator from Banggood, DYS 1306 4000kv motors, Gemfan 3545 props, XM10A escs, 450mAh 3S Nanotech battery and a 140mm frame from Armattan Productions. It weighs 99.9gm and the battery is 40.7gm, AUW is 140.6gm. The other battery I use is an 850mAh 3S weighing 71.5gm, AUW 171.4gm.
Some of the firmware settings are - gyro lpf 41Hz, soft lpf 2nd 88Hz, motor filter on, PPM ESC freq 400Hz, HW I2C speed fast,
motor min 0.12.
The current PID's (tuning is still in progress): float pidkp[PIDNUMBER] = { 4.0e-2 , 4.0e-2 , 1.4e-1 }; float pidki[PIDNUMBER] = { 1.7e-1 , 1.7e-1 , 0.7e-1 }; float pidkd[PIDNUMBER] = { 3.9e-1 , 3.9e-1 , 1.5e-1 };