Table of contents
- Before you start
- Beginner's Guide
- Downloads
- Configuration
- Compatibility
- Telemetry
- WHOOP Section
- Troubleshooting
- SilverHardware
- Go Brushless
- Tuning a quad
- Quadcopter mods
- Merchandise
- Links
Sidebar
more_brushless_setup_info3
This is an old revision of the document!
This LOS quad was built using a GW008 (skull drone) FC with CG023 firmware, buck regulator from Banggood, DYS 1306 4000kv
motors, Gemfan 3545 props, XM10A escs, 450mAh 3S Nanotech battery and a 140mm frame from Armattan Productions. It weighs
99.9gm and the battery is 40.7gm, AUW is 140.6gm. The other battery I use is an 850mAh 3S weighing 71.5gm, AUW 171.4gm.
more_brushless_setup_info3.1472375926.txt.gz · Last modified: 2016/08/28 11:18 by ian446
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
