Silverware Wiki

As this question is being asked from time to time in H8 mini thread, I'll write a short answer here:

1. Install (if not already) STLink Utilities
2. Connect (if not already) STLink to USB port
3. Connect Quad to STLink
4. Power the quad using a battery
5. Click on “target”–>“connect”, some blue writing should be displayed. If not, check Wires, check if the board is powered, are STLink drivers installed correctly?
6. Click on “target”–>“disconnect”
7. Open Keil
8. Unplug & plug quad's battery
9. Click “flash”–>“erase” (if flashed for the first time, otherwise continue step 10)
10. Click “flash”–>“download”
11. Finished