walkera_ladybird_3d
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
walkera_ladybird_3d [2016/05/02 22:25] sirdomsen |
walkera_ladybird_3d [2017/03/15 20:29] (current) sirdomsen |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | =====Walkera Ladybird silverxxxed===== | + | ===== Walkera Ladybird silverxxxed ===== |
| I digged out that little guy. He was only sitting around, because binding with the TX was always luck-dependant. Perhaps a broken layer on the FC? | I digged out that little guy. He was only sitting around, because binding with the TX was always luck-dependant. Perhaps a broken layer on the FC? | ||
| Line 5: | Line 5: | ||
| Anyway, I had to resurrect him! | Anyway, I had to resurrect him! | ||
| - | + | | |
| - | | + | |
| * Flight time with a little weak 333mAh mylipos amazing 7 minutes! | * Flight time with a little weak 333mAh mylipos amazing 7 minutes! | ||
| - | * Motors | + | * Motors |
| + | |||
| + | {{: | ||
| + | |||
| + | < | ||
| + | Some might not see any difference... | ||
| + | </ | ||
| + | |||
| + | {{: | ||
| + | |||
| + | < | ||
| + | ...but that is not an original propeller, is it? So let's remove the Canopy! | ||
| + | </ | ||
| + | |||
| + | {{: | ||
| + | |||
| + | < | ||
| + | A red board? Yeah! I added a H101 FC to it! | ||
| + | </ | ||
| + | |||
| + | {{: | ||
| + | |||
| + | < | ||
| + | I had to cut down the edges to fit under the Canpy. That causes losing the LEDs. | ||
| + | But not a big deal: Stock FC also has a small LED on the top of the Board only... | ||
| + | </ | ||
| + | |||
| + | {{: | ||
| + | |||
| + | < | ||
| + | OK, the Cap is a little large, but was the only one with enough capacity I had laying around... Doesn' | ||
| + | matter, It's not that heavy... | ||
| + | </ | ||
| + | |||
| + | {{: | ||
| + | |||
| + | < | ||
| + | 2mm Goldies for better Battery connection and more " | ||
| + | while laying around, too... | ||
| + | </ | ||
| - | {{:wiki:img_20160401_235006.jpg? | + | {{:wiki:img_20160401_234956.jpg? |
| - | Some might not see any difference... | + | |
| - | {{: | + | < |
| - | ...but that is not an original propeller, isn't it? So let's remove | + | I let him the stock 7x20 motors. They are already run for several hours, |
| + | not a problem, also flying inverted is very cool as because of the heavy motors far away from center, It | ||
| + | flies a bit more chilled. That is cruising | ||
| + | </ | ||
| - | {{:wiki: | + | ==== Update: ==== |
| - | A red board? Yeah! I added a H101 FC to it! | + | |
| - | {{:wiki:img_20160401_235159.jpg?direct&400|}} | + | I recently exchanged the stock ladybird motors with some [[https://www.aliexpress.com/ |
| - | I had to cut down the edges to fit under the Canpy. That causes losing | + | |
| - | But not a big deal: Stock FC also has a small LED on the top of the Board only... | + | |
| - | {{: | + | With stock Ladybird props, I get over 110g of thrust, that' |
| - | + | ||
| - | OK, the Cap is a little large, but was the only one with enough capacity | + | |
| - | matter, It' | + | |
| - | | + | |
| - | {{: | + | {{youtube> |
| - | 2mm Goldies for better Battery connection and more " | + | {{youtube> |
| - | while laying around, too... | + | |
| - | + | ||
| - | {{: | + | |
| - | I let him the stock 7x20 motors. They are already run for several hours, but doing full and half flips is | ||
| - | not a problem, also flying inverted is very cool as because of the heavy motors far away from center, It | ||
| - | flies a bit more chilled. That is cruising! | ||
| - | | ||
walkera_ladybird_3d.1462220759.txt.gz · Last modified: 2016/05/02 22:25 by sirdomsen
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
