Differences

This shows you the differences between two versions of the page.

--- gallery [2017/11/18 15:01]
scruffy1 [Flashing port examples]
+++ gallery [2017/11/18 15:25] (current)
scruffy1 [Flashing port examples]
@@ Line 35: / Line 35: @@
 h8 mini with blue board (note that the clk and dat pads are incorrectly labelled on the board : they are reversed)
-using the same female micro connector as for the h8s-3d; both connect to the ST-link v2 with the same modified servo plug > male micro connector
+using the same female micro connector as for the h8s-3d; both connect to the ST-link v2 with the same modified servo plug > male micro connector, with ground plug closest to the rear (near the battery "hatch")
-{{:img_2274.jpg?300x400|initial soldering}} {{:img_2275.jpg?400x300|secured with epoxy and microballoons}}
+{{:img_2274.jpg?300x400|initial soldering}}{{:img_2275.jpg?400x300|secured with epoxy and microballoons}}{{:img_2276.jpg?nolink&400|finished port}}{{:img_2277.jpg?nolink&400|and again; depron plugs over led's act as diffusers to improve visibility}}
-{{:img_2276.jpg?nolink&400x300|finished port}} {{:img_2277.jpg?nolink&400x300|again, and note depron led diffusers to aid visibility}}

Silverware Wiki