Differences

This shows you the differences between two versions of the page.

--- gallery [2017/11/18 14:57]
scruffy1 [Flashing port examples]
+++ gallery [2017/11/18 15:25] (current)
scruffy1 [Flashing port examples]
@@ Line 27: / Line 27: @@
 h8s-3d, using a 2mm round pin female micro connector
-nothing of the connector is outside the shell, so hopefully this, and being on the side of the machime renders it "safe" from impact
+nothing of the connector is outside the shell, so hopefully this, and being on the side of the machine renders it "safe" from impact
 the final two photos also show the power lead out for akk bs2 camera (whoopin' it up ! )
@@ Line 33: / Line 33: @@
 {{:50079de59b11a255d9b47db82d1c2028.jpg}}{{:48d6379213b5285a0669439a7ac1e32d.jpg}}{{:85f1b6db6058d3b7cfd1b178d7a04840.jpg}}{{:e2806c56da49655dc1daaf196212198d.jpg}}.
-h8 mini with blue board (note that the clk and dat pads are incorrectly labelled on the board : they ae reversed)
+h8 mini with blue board (note that the clk and dat pads are incorrectly labelled on the board : they are reversed)
-using the same micro connector as for the h8s-3d
+using the same female micro connector as for the h8s-3d; both connect to the ST-link v2 with the same modified servo plug > male micro connector, with ground plug closest to the rear (near the battery "hatch")
-{{:img_2274.jpg?300x400|initial soldering}} {{:img_2275.jpg?400x300|secured with epoxy and microballoons}}
+{{:img_2274.jpg?300x400|initial soldering}}{{:img_2275.jpg?400x300|secured with epoxy and microballoons}}{{:img_2276.jpg?nolink&400|finished port}}{{:img_2277.jpg?nolink&400|and again; depron plugs over led's act as diffusers to improve visibility}}
-{{:img_2276.jpg?nolink&400x300|finished port}} {{:img_2277.jpg?nolink&400x300|again, and note depron led diffusers to aid visibility}}

Silverware Wiki

User Tools

Site Tools

Differences

Page Tools