Differences

This shows you the differences between two versions of the page.

--- gallery [2017/10/30 02:29]
scruffy1
+++ gallery [2017/11/18 15:25] (current)
scruffy1 [Flashing port examples]
@@ Line 27: / Line 27: @@
 h8s-3d, using a 2mm round pin female micro connector
-nothing of the connector is outside the shell, so hopefully this, and being on the side of the machime renders it "safe" from impact
+nothing of the connector is outside the shell, so hopefully this, and being on the side of the machine renders it "safe" from impact
-the final photo also shows power lead out for akk bs2 camera (whoopin' it up ! )
+the final two photos also show the power lead out for akk bs2 camera (whoopin' it up ! )
-{{:50079de59b11a255d9b47db82d1c2028.jpg}}{{:48d6379213b5285a0669439a7ac1e32d.jpg}}{{:85f1b6db6058d3b7cfd1b178d7a04840.jpg}}
+{{:50079de59b11a255d9b47db82d1c2028.jpg}}{{:48d6379213b5285a0669439a7ac1e32d.jpg}}{{:85f1b6db6058d3b7cfd1b178d7a04840.jpg}}{{:e2806c56da49655dc1daaf196212198d.jpg}}.
+h8 mini with blue board (note that the clk and dat pads are incorrectly labelled on the board : they are reversed)
+using the same female micro connector as for the h8s-3d; both connect to the ST-link v2 with the same modified servo plug > male micro connector, with ground plug closest to the rear (near the battery "hatch")
+{{:img_2274.jpg?300x400|initial soldering}}{{:img_2275.jpg?400x300|secured with epoxy and microballoons}}{{:img_2276.jpg?nolink&400|finished port}}{{:img_2277.jpg?nolink&400|and again; depron plugs over led's act as diffusers to improve visibility}}

Silverware Wiki

User Tools

Site Tools

Differences

Page Tools