Differences

This shows you the differences between two versions of the page.

--- devo_config [2016/05/16 19:24]
sirdomsen [DEVO 7 with Goebish's Multimodule]
+++ devo_config [2019/01/09 20:40] (current)
sirdomsen [Hints for DIY model files]
@@ Line 1: / Line 1: @@
-====DEVO 7e====
+<font inherit/inherit;;#FF0000;;inherit>Note: H101 model files are backwards compatible with other Silverware quads, just the 3D throttle stuff needs to be disabled/ignored</font>
-[[http://www.rcgroups.com/forums/showpost.php?p=33653759|Model file]] for H8mini Dual mode firmware posted by syvic
+==== DEVO 7e ====
-[[http://www.rcgroups.com/forums/showpost.php?p=34409628|Model file]] for H8mini Dual mode firmware posted by WardoMon
+=== H8 mini ===
-====DEVO 7 with Goebish's Multimodule====
+[[http://www.rcgroups.com/forums/showpost.php?p=33653759|Model file]] for H8mini dual mode firmware posted by syvic
+[[http://www.rcgroups.com/forums/showpost.php?p=34409628|Model file]] for H8mini dual mode firmware posted by WardoMon
+=== H101 ===
+[[http://www.rcgroups.com/forums/showpost.php?p=34814600&postcount=2270|Model file]] for H101 dual mode firmware with 3D throttle enabled posted by SirDomsen
+[[http://www.rcgroups.com/forums/showpost.php?p=34905121&postcount=2490|Another one]] with 3D throttle, posted by HappyHarry
+for inverted controls like on a CP-Heli comment in
+<code>
+//#define NATIVE_INVERTED_MODE
+</code>
+==== Devo 7e with Switchmod ====
+Devo 7E model file with switchable stagility/rattitude mode by RCGroups user Markus Gritsch
+He got inspired by Mike Meyer and added stagility/rattitude/horizon mode to his Devo 7E model file. It requires a modded Devo 7E with two additional 3x switches.
+HOLD:\\
+: normal\\
+: sticky throttle hold (see [[http://www.deviationtx.com/forum/how-to/1953-how-to-create-a-sticky-throttle-hold|http://www.deviationtx.com/forum/how-to/1953-how-to-create-a-sticky-throttle-hold]] for more info)
+SWA:\\
+: linear positive throttle over the full stick range\\
+: positive throttle only in the upper stick range halve\\
+: inverted throttle in the lower stick halve, normal throttle in the upper stick halve – CP heli trainer
+SWB:\\
+: level/angle mode, linear roll and pitch\\
+: stagility/rattitude/horizon mode (change threshold on Ch10, Page 2)\\
+: rate/acro mode, expo on the roll and pitch channels
+FMOD:\\
+: low rates\\
+: high rates
+Throttle trim buttons are used to turn the LEDs on/off
+{{:wiki:h101.zip|H101/H8mini model file & config.h}}
+==== DEVO 7 with Goebish's NRF24_multipro ====
+[[https://github.com/goebish/nrf24_multipro|link to Goebish's Code]]
 Inverted Flight like a CP-heli!!
@@ Line 12: / Line 58: @@
 You have to assign the Channels in Bayang.ino (multimodule Arduino-Sketch) to be as follows:
-  packet[2] = GET_FLAG(AUX3, BAYANG_FLAG_FLIP)            //Assignment for Devo7 + Silverware
-                  | GET_FLAG(AUX2, BAYANG_FLAG_HEADLESS)
+<code>
-                  | GET_FLAG(AUX1, BAYANG_FLAG_RTH)
+packet[2] = GET_FLAG(AUX3, BAYANG_FLAG_FLIP)            //Assignment for Devo7 + Silverware
-                  | GET_FLAG(AUX6, BAYANG_FLAG_SNAPSHOT)  //Not assigned in available in DEVO 7
+                | GET_FLAG(AUX2, BAYANG_FLAG_HEADLESS)
-                  | GET_FLAG(AUX5, BAYANG_FLAG_VIDEO);
+                | GET_FLAG(AUX1, BAYANG_FLAG_RTH)
-        packet[3] = GET_FLAG(AUX4, BAYANG_FLAG_INVERT)
+                | GET_FLAG(AUX6, BAYANG_FLAG_SNAPSHOT)  //Not assigned in available in DEVO 7
+                | GET_FLAG(AUX5, BAYANG_FLAG_VIDEO);
+      packet[3] = GET_FLAG(AUX4, BAYANG_FLAG_INVERT)
+</code>
 H101 has to be configured as descripted [[http://www.rcgroups.com/forums/showpost.php?p=34189408|here]]
+==== DEVO 10 ====
-====DEVO 10====
 [[http://www.rcgroups.com/forums/showpost.php?p=34189408|H101 model file]] for using H101 as a CP-Heli Trainer posted by SirDomsen
+==== Hints for DIY model files ====
+watch the [[:config.h|config.h section]]
+H8 icons for Devo
-====Hints for DIY models====
+[[http://www.rcgroups.com/forums/showpost.php?p=35608494&postcount=76|rcgroups]]
-watch the [[config.h|config.h section]]
-others coming soon

Silverware Wiki

User Tools

Site Tools

Differences

Page Tools