Note: H101 model files are backwards compatible with other Silverware quads, just the 3D throttle stuff needs to be disabled/ignored
Model file for H8mini dual mode firmware posted by syvic
Model file for H8mini dual mode firmware posted by WardoMon
Model file for H101 dual mode firmware with 3D throttle enabled posted by SirDomsen
Another one with 3D throttle, posted by HappyHarry
for inverted controls like on a CP-Heli comment in
//#define NATIVE_INVERTED_MODE
Devo 7E model file with switchable stagility/rattitude mode by RCGroups user Markus Gritsch
He got inspired by Mike Meyer and added stagility/rattitude/horizon mode to his Devo 7E model file. It requires a modded Devo 7E with two additional 3x switches.
HOLD:
0: normal
1: sticky throttle hold (see http://www.deviationtx.com/forum/how-to/1953-how-to-create-a-sticky-throttle-hold for more info)
SWA:
0: linear positive throttle over the full stick range
1: positive throttle only in the upper stick range halve
2: inverted throttle in the lower stick halve, normal throttle in the upper stick halve – CP heli trainer
SWB:
0: level/angle mode, linear roll and pitch
1: stagility/rattitude/horizon mode (change threshold on Ch10, Page 2)
2: rate/acro mode, expo on the roll and pitch channels
FMOD:
0: low rates
1: high rates
Throttle trim buttons are used to turn the LEDs on/off
Inverted Flight like a CP-heli!!
You have to assign the Channels in Bayang.ino (multimodule Arduino-Sketch) to be as follows:
packet[2] = GET_FLAG(AUX3, BAYANG_FLAG_FLIP) //Assignment for Devo7 + Silverware
| GET_FLAG(AUX2, BAYANG_FLAG_HEADLESS)
| GET_FLAG(AUX1, BAYANG_FLAG_RTH)
| GET_FLAG(AUX6, BAYANG_FLAG_SNAPSHOT) //Not assigned in available in DEVO 7
| GET_FLAG(AUX5, BAYANG_FLAG_VIDEO);
packet[3] = GET_FLAG(AUX4, BAYANG_FLAG_INVERT)
H101 has to be configured as descripted here
H101 model file for using H101 as a CP-Heli Trainer posted by SirDomsen