Silverware Wiki

User Tools

Site Tools

Trace:
basic_stock_tx

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
basic_stock_tx [2020/04/19 14:27]
fenrisulven 		basic_stock_tx [2020/04/19 14:28] (current)
fenrisulven
Line 7: Line 7:
 There are 2 ways you can do this, you can use "gestures" or you can use the trim switches on the stock tx. Gestures is the default setup in the firmware, so no changes to the firmware are needed. To use a trim switch some changes need to be made in config.h, scroll down this page for instructions on how to set up a trim switch to change the flight mode. There are 2 ways you can do this, you can use "gestures" or you can use the trim switches on the stock tx. Gestures is the default setup in the firmware, so no changes to the firmware are needed. To use a trim switch some changes need to be made in config.h, scroll down this page for instructions on how to set up a trim switch to change the flight mode.
  
-**[[:gestures|Gestures**]]** is a series of stick movements, left/left/down and right/right/down, that switch a virtual channel AUX 1 in the firmware. This AUX 1 channel can be used to switch from level to acro mode and back again.+**[[:gestures|Gestures]]** are series of stick movements, left/left/down and right/right/down, that switch a virtual channel AUX 1 in the firmware. This AUX 1 channel can be used to switch from level to acro mode and back again.
  
 There are some conditions to using gestures: There are some conditions to using gestures:
basic_stock_tx.1587299266.txt.gz ยท Last modified: 2020/04/19 14:27 by fenrisulven

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki