passthrough
Differences
This shows you the differences between two versions of the page.
|
passthrough [2018/04/05 12:54] sirdomsen created |
passthrough [2018/04/05 12:56] (current) sirdomsen [1. Preparing the board(this is not needed for our dedicated brushless boards).] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== How to use BLHeli Pass-Through for brushless Silverware quads ====== | ====== How to use BLHeli Pass-Through for brushless Silverware quads ====== | ||
| - | ==== 1. Preparing | + | ==== 1. Prepare |
| - | I'll describe here how to prepare a BWhoop board, but the other boards should work smililarly. Be aware that relative fine soldering is needed - but don't be afraid, you only need to remove some stuff from the board. | + | I'll describe here how to prepare a BWhoop board, but the other boards should work smililarly. Be aware that relative fine soldering is needed - but don't be afraid, you only need to remove some stuff from the board. A hot air gun or second soldering iron is helpful, but not needed. |
passthrough.1522925672.txt.gz ยท Last modified: 2018/04/05 12:54 by sirdomsen
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
