This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
e011 [2018/03/26 05:13] brianquad Add channel mapping for stock transmitter |
e011 [2018/09/04 13:35] (current) bla |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| the " | the " | ||
| - | {{https:// | + | {{https:// |
| it now is also supported by Silverware. Instructions similar to [[: | it now is also supported by Silverware. Instructions similar to [[: | ||
| Line 13: | Line 13: | ||
| If you're trying to flash the E011C (Santa edition) then check[[https:// | If you're trying to flash the E011C (Santa edition) then check[[https:// | ||
| This board is slightly different than the E011 in that it uses different pins for the radio and for two of the motors. | This board is slightly different than the E011 in that it uses different pins for the radio and for two of the motors. | ||
| - | |||
| - | **E011 Stock Firmware Channel Mapping (Bayang protocol): | ||
| - | Ch 1 - Aileron/ | ||
| - | Ch 2 - Elevator/ | ||
| - | Ch 3 - Throttle\\ | ||
| - | Ch 4 - Rudder/ | ||
| - | Ch 5 - Flip mode (kinda like horizon mode, where extreme Roll/Pitch makes the E011 flip)\\ | ||
| - | Ch 6 - Return to Home\\ | ||
| - | Ch 9 - Headless Mode | ||
| - | |||
| - | Open Question: How does the Brick Figure mode switch? Is it mapped to a channel, or just a throttle limit in the stock transmitter? | ||