This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
brushless_setup [2016/07/25 09:33] ian446 |
brushless_setup [2016/11/12 10:17] (current) silverxxx |
||
---|---|---|---|
Line 45: | Line 45: | ||
Blheli has option to use "pwm input", | Blheli has option to use "pwm input", | ||
- | **SAFETY NOTES** | + | ==== Safety ==== |
+ | |||
+ | Keep in mind not to flash the fc with the escs powered. | ||
+ | |||
+ | In the H101 and the current CG023 , the FC will turn off PPM at failsafe and before bind, so it should be safe to flash, but just in case, I don't recommend. However, not safe if the tx is bound and on. | ||
+ | |||
+ | The h8green , and currently blue as it has not been updated, they are not safe to flash while the escs are powered. It's rare, but they can turn on (full power) if the signal cuts off at just the right time. | ||
Always consider that the quad may malfunction, | Always consider that the quad may malfunction, |