Differences

This shows you the differences between two versions of the page.

--- brushless_setup [2016/07/25 04:39]
silverxxx
+++ brushless_setup [2016/11/12 10:17] (current)
silverxxx
@@ Line 45: / Line 45: @@
 Blheli has option to use "pwm input", PPM input is always enabled. Oneshot125 is also always enabled, and autodetected, but may interfere with the pwm input. Blheli will autodetect the input type after powerup. "Enable pwm input" should be set to off if not used, and "programming by tx" unchecked as well.
-**SAFETY NOTES**
+==== Safety ====
+Keep in mind not to flash the fc with the escs powered.
+In the H101 and the current CG023 , the FC will turn off PPM at failsafe and before bind, so it should be safe to flash, but just in case, I don't recommend. However, not safe if the tx is bound and on.
+The h8green , and currently blue as it has not been updated, they are not safe to flash while the escs are powered. It's rare, but they can turn on (full power) if the signal cuts off at just the right time.
 Always consider that the quad may malfunction, and may go full power suddenly. Do not flash the quad with the escs connected/powered. Always remove props when testing. Do not fly quads that have severe oscillation/wobbles.
@@ Line 54: / Line 60: @@
 H101 esc driver : ([[http://www.rcgroups.com/forums/showpost.php?p=35266396|rcgroups]])
+H8 mini green board esc driver: ([[http://www.rcgroups.com/forums/showpost.php?p=34408240|rcgroups]])

Silverware Wiki