Differences

This shows you the differences between two versions of the page.

--- more_brushless_setup_info2 [2018/01/12 21:36]
ian446
+++ more_brushless_setup_info2 [2018/05/15 21:43] (current)
ian446
@@ Line 19: / Line 19: @@
 {{http://static.rcgroups.net/forums/attachments/4/7/0/8/6/1/a9431072-255-H101 caps.JPG?nolink&700x700  |static.rcgroups.net_forums_attachments_4_7_0_8_6_1_a9431072-255-h101_caps.jpg}}
-Don't forget to set the output signal polarity in the firmware, each method requires a different output signal polarity, because the signal is inverted when it passes through the FET. The esc's will not spin the motors if the polarity is set wrong.
+Don't forget to set the output signal polarity in the firmware, each method requires a different output signal polarity, because the signal is inverted when it passes through the FET. The esc's will not spin the motors if the polarity is set wrong. Refer to [[:more_brushless_setup_info|this page]] under the heading "**How to set up PPM/Oneshot".**
 POWERING THE FC
@@ Line 58: / Line 58: @@
 \\
 {{:e011_voltage_divider.jpg?nolink&|e011_voltage_divider.jpg}}
+TELEMETRY BATTERY VOLTAGE MONITORING FOR BWHOOP B-03 FC
+{{:dscf0413ta.jpg?nolink&|dscf0413ta.jpg}}

Silverware Wiki