docs:readme
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
docs:readme [2017/10/20 08:03] markus_gritsch [Pid tuning using gestures] |
docs:readme [2019/01/09 20:34] (current) sirdomsen [Gestures] |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ====== Installation ====== | ====== Installation ====== | ||
| - | Because of differences between boards, installation is covered by a rcgroups post. For linux instructions use the install.md file. | + | Because of differences between boards, installation is covered by a rcgroups post. For linux instructions use the install.md file. (See also [[: |
| + | |||
| + | For MacOS, see below | ||
| ====== Settings ====== | ====== Settings ====== | ||
| Line 22: | Line 25: | ||
| The default protocol used is Bayang, a modification of it allows use of telemetry on transmitters which support it, such as Devo 7e with Deviation installed for example. Telemetry needs to be enabled in the transmitter, | The default protocol used is Bayang, a modification of it allows use of telemetry on transmitters which support it, such as Devo 7e with Deviation installed for example. Telemetry needs to be enabled in the transmitter, | ||
| - | |||
| ====== Gestures ====== | ====== Gestures ====== | ||
| Line 31: | Line 33: | ||
| < | < | ||
| - | Down - Down - Down: Accelerometer calibration / Save pids if changed | + | Down - Down - Down: Accelerometer calibration / Save pids & bind state if changed |
| Left - Left - Down: acro mode | Left - Left - Down: acro mode | ||
| Line 40: | Line 42: | ||
| Up - Down - Left: Decrease the selected value | Up - Down - Left: Decrease the selected value | ||
| Up - Down - Right: Increase the selected value | Up - Down - Right: Increase the selected value | ||
| + | |||
| + | Up - Up - Up: Auto-Bind ON (1 blink) | ||
| + | Up - Up - Up: (again) Auto-Bind OFF (2 blinks) | ||
| </ | </ | ||
| Line 45: | Line 50: | ||
| ====== Pid tuning using gestures ====== | ====== Pid tuning using gestures ====== | ||
| - | The pids can be tuned and saved via gestures, or by editing the pid.c file. Saving the pids after changing them using gestures, they will remain active after a power cycle. They will remain usable even after flashing a firmware to the quad again, provided the pid.c values have not changed since the last upload. | + | The pids can be tuned and saved via gestures, or by editing the pid.c file. Saving the pids after changing them using gestures, they will remain active after a power cycle. They remain usable even after flashing a firmware to the quad again, provided the pid.c values have not changed since the last upload. |
| + | |||
| + | <font 28px/ | ||
| + | <font 14px/ | ||
| ====== More Information ====== | ====== More Information ====== | ||
docs/readme.1508479413.txt.gz · Last modified: 2017/10/20 08:03 by markus_gritsch
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
