Silverware Wiki

User Tools

Site Tools

Trace:
bwhoop_ah

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
bwhoop_ah [2018/04/01 20:33]
mrvanes 		bwhoop_ah [2018/04/02 14:04] (current)
mrvanes
Line 2: Line 2:
  
 Altitude Hold version of Silverware can be found in [[https://github.com/silver13/BoldClash-BWHOOP-B-03/tree/AH|AH branch of Silverware]]. Altitude Hold version of Silverware can be found in [[https://github.com/silver13/BoldClash-BWHOOP-B-03/tree/AH|AH branch of Silverware]].
 +
 +|[[http://www.boldclash.com/boldclash-bwhoop-b-03-receiver-p54.html|{{:bwhoop_baro.jpg?nolink&200|BWHOOP B-03 (with barometer)}}]]|[[http://www.boldclash.com/boldclash-bwhoop-b03-pro-03-receiver-board-p123.html|{{:bwhoop_pro.jpg?nolink&200|BWHOOP B-03 Pro (without barometer)}}]]|
 +
 +On the left, the barometer Bwhoop B-03 can be recognized by the pressure filter foam pad. On the right is the BWHOOP B-03 Pro, //without// barometer.\\
 +\\
 +On linux, a branch can be checked out like this:
  
 <code> <code>
Line 21: Line 27:
 </code> </code>
  
-Added configuration (config.h)+Added configuration (config.h) options:
  
 <code> <code>
Line 38: Line 44:
 **USE_STOCK_SPRINGLOADED_HOLD** is a poor man's altitude hold. This makes center throttle 0% throttle //adjust//, and adds or decreases throttle when pushing or pulling throttle (using a ^5 exponential curve for easier adjustments around centre). Center will keep the last throttle, so when carefully adjusted this will keep the drone in place. Be careful, I tend to overshoot quite a lot while trying this mode. **USE_STOCK_SPRINGLOADED_HOLD** is a poor man's altitude hold. This makes center throttle 0% throttle //adjust//, and adds or decreases throttle when pushing or pulling throttle (using a ^5 exponential curve for easier adjustments around centre). Center will keep the last throttle, so when carefully adjusted this will keep the drone in place. Be careful, I tend to overshoot quite a lot while trying this mode.
  
-**ENABLE_BARO** Enables Barometer supported altitude hold. This is best used in combination with **USE_STOCK_SPRINGLOADED_TX**. In ENABLE_BARO mode the drone starts off when armed, throttle up will quickly ascend the drone to ~50cm. Holding down the throttle (< 85%) for more than one second switches off motors.+**ENABLE_BARO** Enables barometer supported Altitude Hold. This is best used in combination with USE_STOCK_SPRINGLOADED_TX. In ENABLE_BARO mode the drone starts off when armed, throttle up will quickly ascend the drone to ~50cm. Holding down the throttle (< 85%) for more than one second switches off motors.
  
  
bwhoop_ah.1522607636.txt.gz ยท Last modified: 2018/04/01 20:33 by mrvanes

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki