Differences

This shows you the differences between two versions of the page.

--- basic_stock_tx [2020/04/19 14:27]
fenrisulven
+++ basic_stock_tx [2020/04/19 14:28] (current)
fenrisulven
@@ Line 7: / Line 7: @@
 There are 2 ways you can do this, you can use "gestures" or you can use the trim switches on the stock tx. Gestures is the default setup in the firmware, so no changes to the firmware are needed. To use a trim switch some changes need to be made in config.h, scroll down this page for instructions on how to set up a trim switch to change the flight mode.
-**[[:gestures|Gestures**]]** is a series of stick movements, left/left/down and right/right/down, that switch a virtual channel AUX 1 in the firmware. This AUX 1 channel can be used to switch from level to acro mode and back again.
+**[[:gestures|Gestures]]** are series of stick movements, left/left/down and right/right/down, that switch a virtual channel AUX 1 in the firmware. This AUX 1 channel can be used to switch from level to acro mode and back again.
 There are some conditions to using gestures:

Silverware Wiki